济南防水http://www.tianyujian.com/介绍把防水层做在找平层与刚性层之间，既起了隔离层的作用，又不被日晒雨淋，既防止油膏老化，又起了防水作用。
1、济南防水基层上涂刮基层处理剂，要求薄而均匀，一般干燥后，当不粘手才能铺贴卷材。
Jinan waterproof coating on scratch grassroots primary treatment agent, thin, uniform requirements, usually after dry, sticky when to Stones roll.
2、济南防水卷材防水层的铺贴一般应由层面最低标高处向上平行屋脊施工，使卷材按水流方向搭接，当屋面坡度大于10%时，卷材应垂直于屋脊方向铺贴。
Paving Jinan waterproofing membrane waterproof layer should normally be at the level of the lowest elevation parallel upward roof construction, so that the flow direction of the coil by lap, when the roof slope greater than 10%, the web
should be perpendicular to the direction of the roof tiling.
3、济南防水铺贴方法：剥开卷材脊面的隔离纸，将卷材粘贴于基层表面，卷材长边搭接保持50mm，短边搭接保持70mm，卷材要求保持自然松弛状态，不要拉得过紧，卷材铺妥后，应立即用平面振动器全面压实，垂直部位用橡胶榔头敲实。
Jinan waterproof paving method: Strip the membrane surface ridge release paper, the membrane attached to the primary surface, roll the long side of the lap to keep 50mm, short side lap keep 70mm, coil required to maintain the natural relaxed state, do not pull too tight, roll shop after properly, you should immediately fully compacted plane vibrators, vertical area with a rubber hammer to knock reality.
4、济南防水http://www.tianyujian.com/卷材压实后，将搭接部位掀开，用油漆刷将搭接粘接剂均匀涂刷，在掀开卷材接头之两个粘接面，涂后干燥片刻手感不粘时，即可进行粘合，再用橡胶榔头敲压密实，以免开缝造成漏水，防水层施工温度选择5℃以上为宜。
Jinan waterproofing membrane after compaction, the site will open a lap, lap adhesive paintbrush will even brushing, opened both in the adhesive surface of the membrane joints, painted after a while feel sticky when dry, bonding can be
carried out, then the rubber hammer to knock compacting pressure to avoid slotted cause water leakage, waterproof layer construction temperature above 5 ℃ appropriate choice.
