济南专业防水http://www.tianyujian.com/谈到进行家庭防水施工时，管道处理是重点也是难点。如果之前没有做好基层修补，松动后容易渗水，如果涂刷过厚，在还没有完全表干的情况下，因热胀冷缩系数的不同，引发干缩裂缝，严重时就会导致渗漏。
1、济南专业防水谈到应仔细查找渗漏位置，如果确定仅是管口部位，则将周边的基面凿开，使用管口灌浆料或堵漏网进行填充加固。再围着管道渗水点周围做一个半径为20cm的基面区域，对基面进行处理，使基面达到干净、平整、坚固，充分湿润基面后涂刷柔韧型防水浆料。注意，单次涂刷不要太厚，不能超过1mm，多次涂刷时要等上一次的涂刷基本干固（刚好不粘手），总厚度不能超过2mm。
Jinan professional waterproof spoke carefully to find the leak location, only if it is determined that the nozzle area, then scuttling around the base, using a nozzle plugging slipping through the net or grout fill reinforcement. Again around the pipe around the seepage point doing a radius of 20cm base surface area of the base surface for processing, so that the base surface to reach a clean, smooth, strong, full wet base after brushing flexible waterproof slurry.Note that a single brush not too thick, not more than 1mm, repeatedly brushing time to wait for the last time to dry brushing basic (just not sticky), the total thickness of no more than 2mm.
2、济南专业防水http://www.tianyujian.com/介绍专门针对管道口做闭水试验检查，在管道周围围成一个密封区域，尽可能提高试水高度，不得低于20cm，从楼下观察管道是否有水渗出，如果没有，则管道渗水处理成功。如果是出现多处渗漏，或是难以确定漏水的位置，建议把整个卫生间的瓷砖打掉，做好管口锚固后重新进行全面的防水处理。
Jinan professional waterproof introduce specialize mouth closed water test for pipeline inspection, around the pipe surrounded by a sealing area, improve test the water height as possible, not less than 20cm, from downstairs to observe
whether there is water leaking pipes, and if not, pipeline seepage treatment success. If the emergence of multiple leaks, or is difficult to determine the location of leaks, it is recommended to knock down the entire bathroom tiles and
do a full re-waterproofing treatment nozzle anchor.
