您好!欢迎访问济南诚誉防水工程公司网站!
专注济南防水工程,防水材料,防渗工程贴心的服务,合理的收费,热诚期待您的来电!
全国咨询热线:155-5313-7958
联系我们

【 微信扫码咨询 】

155-5313-7958

济南专业防水介绍屋面隔离层的做法

作者:admin 浏览量:202次 来源:本站 时间:2022-12-28 15:23:06

信息摘要:

济南专业防水介绍基层上涂刮基层处理剂,要求薄而均匀,一般干燥后,当不粘手才能铺贴卷材;卷材防水层的铺贴一般应由层面最低标高处向上平行屋脊施工,使卷材按水流方向搭接,当屋面坡度大于10%时,卷材应垂直于屋脊方向铺贴。

济南专业防水http://www.tianyujian.com/介绍在酸雨较重、湿度大、腐蚀性较强的地区,一般施工单位普通做法是在找平层上刷冷底子油当作隔离层用,之后就浇刚性防水层,为保证屋面三年的保修期内不漏水,又在刚性层上做一道二布三油防水层,工程验收时,甲方看到屋面黑油油的又好看,其实这样将油膏放在面层,容易老化,使用年限不长,三年后又来补漏。为了避免这类情况发生,在施工中因地制宜,取长补短,把面上的这一层二布三油卷材防水层做在找平层与刚性层之间,既起了隔离层的作用,又不被日晒雨淋,既防止油膏老化,又起了防水作用。

1、济南专业防水介绍基层上涂刮基层处理剂,要求薄而均匀,一般干燥后,当不粘手才能铺贴卷材;卷材防水层的铺贴一般应由层面最低标高处向上平行屋脊施工,使卷材按水流方向搭接,当屋面坡度大于10%时,卷材应垂直于屋脊方向铺贴。
Jinan professional waterproof introduce Scraping the grassroots primary treatment agent, thin, uniform requirements, usually after dry, sticky when to Stones roll; Stones should normally be the minimum level of waterproofing membrane at

a parallel upward elevation roof construction, coil according to the flow direction so that the lap, when the roof slope greater than 10%, the roof membrane should be perpendicular to the direction of paving.

2、济南专业防水谈到剥开卷材脊面的隔离纸,将卷材粘贴于基层表面,卷材长边搭接保持50mm,短边搭接保持70mm,卷材要求保持自然松弛状态,不要拉得过紧,卷材铺妥后,应立即用平面振动器全面压实,垂直部位用橡胶榔头敲实。
Jinan professional waterproofing membrane lands comes to ripping isolation paper, the membrane attached to the primary surface, roll the long side of the lap to keep 50mm, short side lap keep 70mm, coil required to maintain the natural relaxed state, do not pull too tight, roll shop after properly, you should immediately fully compacted plane vibrators, vertical area with a rubber hammer to knock reality.

3、济南专业防水http://www.tianyujian.com/提醒卷材压实后,将搭接部位掀开,用油漆刷将搭接粘接剂均匀涂刷,在掀开卷材接头之两个粘接面,涂后干燥片刻手感不粘时,即可进行粘合,再用橡胶榔头敲压密实,以免开缝造成漏水;防水层施工温度选择5℃以上为宜。
Jinan professional waterproofing membrane compaction reminder, the site will be opened lap, lap paintbrush brushing uniform adhesive bonding surface coils in both joints opened it, after a while feel dry non-stick coating when the bond

can be carried out, then the rubber hammer to knock compacting pressure, in order to avoid leaks caused slotted; waterproof layer construction more than 5 ℃ temperature selection is appropriate.