彩钢板表面防水是多方面的，大多数是工序之间忽视了防水，个人只顾在自己的工序段负责，不考虑工序的衔接。下面济南防水介绍一下彩钢板表面防水应该注意哪些问题？
1、排水，从瓦上、天窗、烟囱、排气空、瓦的交角处查看排水是否流畅将积水排走。
Drainage from the tile, skylights, chimneys, exhaust air, tile drainage is smooth viewing angle at the water to drain away.
2、堵水，在辅设的防水层上面找出漏水点将防水层修补好把水堵住。
Shutoff, the waterproof layer on top of the auxiliary set point to find leaks and repaired water waterproof layer blocked.
3、引水，这是最下等的做法，也就是说在找不到漏水点的情况下才使用的一种办法，将积聚在保温层中的水引到外边，将瓦退掉,砸开保护层、去掉防水层、找平层将露出的保温层积水多的部位划上记号再去掉保温层并清理干净。在清净的混凝土板上找出漏水点，用防水宝材料堵住，然后大面作一道防水层，在有记号处设置排水口，然后回填找平。重心做防水处理，并要和原来的防水层搭接好，做好保护层将瓦装好，清理好现场。
Water, which is the most inferior way, one way is to say in the case can not find the leak point was used to accumulate in the insulation layer of water to the outside, the tile drained away,broke down the protective layer, remove the waterproof layer, insulating layer and the exposed water screed, marks the site of more then remove insulation and clean. In clean the concrete slab to find the leakage point, with waterproof material treasure blocked, then Omo as a waterproof layer, there is provided at the outlet mark, then backfill leveling. Waterproof treatment center, and to
the original waterproof layer overlap, and do protective layer watt installed, cleaned up the scene.
